Paragon GL-18AD Glass Fusing Kiln

SHOWN IS THE GL18ADTSD

The spring-pressure latch and a ½" recess around the edge of the firebrick door seal the door tight. The door remains rock-steady on a heavy hinge shaft. Four hand lifts aid moving. The base is open in the back and slotted to dissipate heat.

Watch the red-hot glass through two tapered peepholes, drilled one above the other in the wall opposite the switch box. Peephole plugs are included.

Optional Kiln Stand

The heavy-duty GL-series stand raises your GL-18, GL-22 or GL-24 kiln to a convenient working height. Begin operating your new kiln without having to find a table strong enough to support over 300 pounds. The table is 147 pounds of rock solid construction.

ST-8: without casters—30 ¼” square x 28 ¼” high, 147 lb.

ST-8-1: with 2" steel casters—30 ¼" square x 30 ¾” high, 150 lb.

The Optional Furniture Kit (not included):  Fits GL-18 Series

Glass must always be fired on a shelf and never directly on the kiln’s firebrick bottom.

1 - C-17 - 16” x 14” Shelf

4 - 1” wide Square Posts, ½” long

1 lb. Bag Glass Separator

Specifications